Nice little amp Before I review, I would like to say I am reviewing this product from a perspective as a gigging instrumental acoustic guitarist. Had to do an outdoor gig with no electric outlets Read complete review Before I review, I would like to say I am reviewing this product from a perspective as a gigging instrumental acoustic guitarist. Had to do an outdoor gig with no electric outlets available, that’s when i looked into buying this thing, and it did the trick. Also had to fly somewhere across the country to do a gig where the venue didn’t have a PA system, and I was able to pack this in my luggage, and this little thing did the job. For a tiny amp only a bit bigger than a Kleanax box, this thing is plenty loud. It’s able to emmenate the volume to within about a square feet coverage.
How can I connect my iPod or other audio device to my car radio?
Next Audiophiles know that a stereo is not complete until you’ve added a subwoofer to your system. The subwoofer is a speaker specifically designed to give precise sound to low frequency audio, such as the bass [source: Whether in your car or your home theatre, a subwoofer is a must for a true and complete audio experience. Read the steps listed below and learn about how to connect a subwoofer to an amplifier.
Mar 03, · Best Answer: your best bet is to try and rewire it by stripping the wires down and splicing them with the hookup for your amp or try to find an adapterStatus: Resolved.
There are a wealth of kits on the market with cables, modules, and even transmitters to help you do just that. However, the choices can be confusing and overwhelming in many cases. Here, a “USB” jack and port are shown, as typically used on a personal computer. These are typically used for home and car stereos. In this article, we’ll take a look at the types of portable device-to-car-radio connection kits offered to help you make an informed decision for yourself or someone you care about.
In some cases, you’ll be asked for the specific model of your portable product to determine the jack size needed after entering the Product Options field. For devices which are vehicle-specific, you will be asked to provide the year, make and model of your ride. Why Are Adapters Needed? Why are adapters needed? In short, most mobile devices are designed to be connected to USB ports like those found on a computer and most car stereos are set up for RCA cables which feature white and red male ends similar to those found on a traditional home stereo.
The two types of jacks are not the same, and they must be made compatible. Also, any conversion setup needs to change the digital signals from MP3s into analog types of signal required by most car radios. They plug into your cigarette lighter adapter, then connect by wire to your MP3, Apple, Android, portable CD player, or other audio device.
How To Hook Up A 4 Channel Amp Into Stock Radio Stereo
So you want to keep the factory amp? I wouldn’t suggest that. I’d recommend getting rid of the factory amp altogether, they’re usually not the best, and it would be difficult – if not impossible – for them to work together.
About Amplifiers. Kicker amplifiers provide amazing power, control, and flexibility, accompanied by a sleek design. With a focus on quality and design, our car amps allow you to command the sound within your .
PA-Performance is widely know for their high performance charging and starting systems. They have specialized in high output alternators for the Mustang for nearly a decade. Now this is a amp 6G series alternator that comes complete with an internal voltage regulator and a pulley that allows you to reuse your factory belt. Although, I would recommend replacing your belt while you’re in the area, since you’re going to be replacing your alternator anyway.
This is a direct replacement that increases the charging capacity at all rpm ranges without any modification necessary. Providing amps of idle and amps at max. Now I will say because this unit provides higher than stock output, you will need to upgrade your main power wire. This is because the stock OE power wire was not designed to handle the increase load that this high amp alternator provides.
Luckily PA-Performance offers this upgrade and it’s available in the drop-down menu on the product page. If you’re not already there just click the link below and see what I’m talking about. For installation you can expect to spend about two hours tackling the job with the use of basic hand tools. Now because this is a direct replacement you do not have to modify the mounting bracket.
Can I hook my car subwoofers up to my home reciever?
Next If your subwoofer doesn’t have an internal amplifier , you’ll definitely want to connect an amplifier to it. To do this, you’ll need your subwoofer, an amplifier, at least one set of RCA cables these are the red, white, and yellow jacks on a single cable , speakers , and speaker wires. First, you’ll want to think about where you’ll keep the subwoofer.
Because the subwoofer is working mostly on the bass the low tones , it doesn’t require as much directional pushing as speakers do. Since you’ll have to run cables and wires between the subwoofer and other devices, you might want to keep it just a few feet from your screen. To get started with the actual hook-up, you’ll connect the subwoofer to the amplifier using the RCA cable.
· How to hook up powered subwoofer to amplifier? First off, let’s gather a bit of info. I assume (and I believe everyone else) this is for the home, and not a car stereo. out (as immtbiker said), then you can mate it up. Otherwize, I wouldn’t know how to accomplish it. The easiest thing to do may be to look for a different amp or receiver
Comment Subscribe to comments with RSS. CampRicco I have two battery banks. I want to be able to plug portable bank into stationary bank for charging. Should I be concerned about the inrush current when connecting portable bank into stationary bank while battery charges are equalizing. Can a resistor be added to cable to slow current while banks are equalizing. If so where in connection and what value would you recommend.
The two battery packs you have are of different capacity, so you are creating a situation where batteries are going to get overcharged. I would recommend charging them separately. My question is can I use 1 battery for my outboard for a 12 volt starting and charging system without disconnecting the 2 batteries.
How can i hook up “party” speakers for my laptop? Thanks!
Speakers Clint DeBoer Speaker Impedance Rating Explained That speaker impedance rating on your towers and bookshelf speakers is held up as a mystery—something strange and mystic, yet dangerous. The bottom line is that people are confused about speaker impedance. Speaker Impedance Defined I think the easiest way to define speaker impedance is to say that it is the resistance any speaker gives to the current and voltage being applied to it.
In a nutshell, a loudspeaker is a big resister—a really cool one. Speaker impedance changes based on the frequency of the signal fed into it. The loudspeaker manufacturer likely developed a 4-ohm speaker because he know what kind of amplifier would be required or typically mated with it to get the desired sound.
That speaker impedance rating on your towers and bookshelf speakers is held up as a mystery—something strange and mystic, yet dangerous. I have two 6*ohm speakers and a 2-channel watt car amp (ie. 12V battery of car). Can i connect these? If yes, please tell how. Can I hook up these speakers to 6 ohms receiver as I see most of the.
The Prius in ready mode will keep the traction battery and 12 volt battery fully charged automatically as long as you have gas in the tank. In the ready mode you will be running your equipment and the 12 volt equipment in the car off the power provided by the dc-dc converter. As was stated before you will have to make sure the amplifier is really off and not drawing any current when you turn off the car and leave the ready mode.
Additionally you cannot run the car in accessory or ign on mode for very long if your amplifier is on as the Prius dc dc converter doesn’t operate in these modes. In these modes the Prius is running completely off the 12 volt battery which as you have discovered, has a pretty small energy capacity. If you mean an audio capacitor is a capacitor placed across the 12 volt input to your equipment, such a capacitor will limit the current peaks drawn from your 12 volt system, but will not change the energy available from the battery.
In other words your equipment will still run down the battery just as fast if you’re not running in the ready mode. And as stated above, fuse your wiring at the 12 volt source battery and run your power wiring directly to the battery through that fuse.
How do you connect a subwoofer to an amplifier?
How to install an Amplifier: Disconnect the battery terminals: Run the power cable from the battery to the location of the amp or distribution block.
i have a kenwood car stereo and it has an rca output for a subwoofer can i just get an rca cable and connect a subwoofer directly or do i need to connect the rca output to an amp and then to a subwoof .
Hope this information helps. Jan 10, , 7: Alternators of this size are typically found on large diesel trucks, whereas A’s on Pickups, and typically A on cars stock. You would probably be fine pushing a watt PSU into the Amp, however check the 12V rails for maximum wattage, even if you got Watts, that would be about the maximum you could get from a car alternator if you never upgraded it. Meaning little to no change from what was in your car, assuming no upgrades.
That likely wont totally max your amp, but its unlikely your amp actually put outs more than rms. Zeeboii im looking for a psu for my amp that is rated at watt peak and w rms, dont know which psu to buy help me out lakimens Aug 4, , You could probably use a car battery charger not sure or a bench power supply, both are expensive options, no doubt.
Hooking up a car audio system with 3 amps and 4 subs?
How to Install an Aftermarket Amplifier If you’re not satisfied with the sound output of your Honda’s stock stereo system, you can improve it with an amplifier. Learn how to do it yourself and save money. If you want more sound from your Honda’s stock audio system, then an aftermarket amplifier is a welcoming upgrade. Even if you upgrade your audio system with better speakers or head units—without adding an amplifier—the sound quality won’t improve.
Wearing headphones in the car can be dangerous and is illegal in a number of states. Luckily, it isn’t difficult to connect your portable MP3 Player to your car audio system. Everyone riding in your vehicle can enjoy your music through your car stereo easily and safely. These are the top ways to enjoy your portable MP3 player through your car stereo.
While Chevy Volt owners will be able to get away with charging their cars off of a standard V wall outlet, Nissan LEAF customers will only be able to buy a LEAF if they’ve either completed the installation of a home charging unit from Nissan’s exclusive contractor, AeroVironment, or signed a waiver with Nissan certifying that they’ve installed their own charging equipment. The difference comes down to the size of the battery pack. Given that the LEAF is really the only mass-market car in need of installation of a Level II home charger until about , the demand for home charging units from other companies besides AeroVironment will likely be low until then, unless a significant amount of early adopters choose to organize the installation of their own chargers.
Yet that hasn’t stopped a handful of companies from jumping headlong into the world of charging stations. Early on, AeroVironment was really the only company that had devoted itself to developing and building Level II home charging units More than anything else, this probably played a big role in why they got the contract from Nissan to conduct all of the early adopter installations.
In light of this, the other companies that have committed to building charging stations have initially focused on industrial quality units—mostly for commercial and municipal installations—but that is slowly changing as we get closer to the launch of the first mass-market EVs. So now that you’ve got the lay of the land, who are the companies selling the chargers?
ECOtality ECOtality North America formerly eTec has been at the charging station game for quite some time, having developed the Minit-Charger system to quick charge such industrial equipment as electric forklifts. With all of that background they have taken the Minit-Charger and applied it to both residential and commercial charging stations. As the manager behind the public-private EV deployment partnership known as ‘ The EV Project ‘—which seeks to install thousands of charging stations in 5 deployment states over the next year—ECOtality is also in the business of installing charge stations that are not their own.
In an attempt to liven up their rather staid image, ECOtality has just announced a new lineup of home and commercial Level II charging stations.
Honda: How to Install an Aftermarket Amplifier
Comment Subscribe to comments with RSS. I read your blog often and you always post excellent content. I posted this article on Facebook and my followers like it. Thanks for writing this!
· If the car has a stock stereo with an amp, you can still do it, just make sure the wires are spliced properly and between the stock amp and the speakers, not the deck and stock amp. kcgrant28 · ?qid=AAYASof.
And a big part of that information is our music collection. It most probably occupies the biggest part of the SD card on our smartphone, and we would like to listen to it anywhere and anytime. And a part of our day where we would want to listen to our music is when we drive in our cars, going from place to place, but also in our home, when we like to plug in our smartphones to the audio system and start relaxing.
There are a few options that work with your existing audio system, the old fashioned one, with just a few modifications. Of course, newer models of car stereos or home audio systems already have Wi-Fi or Bluetooth connectivity and can be connected to many devices such as smartphones and tablets. Depending on which device you want to connect your smartphone, there are a few options available. Newer models, sometimes called smart radios now have this feature integrated.